Need a bespoke electronic component designed?

Look no further...  when the control components you need simply aren't available off the shelf, our in house engineers have the experience to design and manufacture bespoke components to your specification. 

Some of our in house design solutions are outlined below:-

Bespoke Printed Circuit board from DnA
DnA custom designed and built circuit board.

Printed Circuit Manufacture

All printed circuit boards used in our bespoke equipment is electronically designed and produced to the highest standards.

Bespoke SSI Encoder from DnA
Bespoke SSI Encoder from DnA

SSI Encoder Interface

Designed to interface to 25Bit SSI encoders this unit produces a 4 to 20mA signal to allow remote monitoring of feedback position. 

  • Scaling and offset adjustment is provided via digital parameters.
  • An LCD display indicates Measured Position and allows simple parameter adjustment.
  • Two relays outputs are available to indicate Presettable positions.
  • Supply 20-30V DC reverse polarity protected.
2 ultra stable field supplies of 100mA @ 200V. Field failure relay outputs are included.
Bespoke Dual Field Controller - this unit provides 2 ultra stable field supplies of 100mA @ 200V

Dual field controller

The unit shown was designed and installed on a multi stand steel processing line, and provides 2 ultra stable field supplies of 100mA @ 200V.  Field failure relay outputs are included.

provides a ramped analogue output to control the motor fields on a multi stand steel wire line
Providing a ramped analogue output to control the motor fields on a multi stand steel wire line.

Ramp board

This board provides a ramped analogue output to control the motor fields on a multi stand steel wire line.  Controls are included to ease the setting up and provide outputs for feedback purposes.